Edelbrock Automobile Parts R09430 User Manual

Front Brake Hose Kit

for 2004-2006 Yamaha Rhino

Catalog #R09430, #R09431

INSTALLATION INSTRUCTIONS

Please study these instructions carefully before installing your new Brake Hose Kit. If you have any questions, please call

our Technical Hotline at: 1-800-416-8628, 7:00 am - 5:00 pm, Pacific Standard Time, Monday through Friday or

e-mail us at Edelbrock@Edelbrock.com. Please fill out and mail your warranty card.

IMPORTANT NOTE:

Proper installation is the responsibility of the installer. Improper installation will void warranty and may

result in poor performance and engine or vehicle damage.

INSTALLATION INSTRUCTIONS

IMPORTANT NOTE: Do not allow the master cylinder to completely drain of brake fluid at any time during this process.

Also, use care when handling brake fluid, as it can quickly damage finished surfaces (paint, plating, etc.).

1. Remove factory brake hoses, noting routing. NOTE: Factory cable tie-style hose retainers are re-usable - pull tab

on locking end of tie away from strap to release (See Fig. 1).

2. Route Russell upper hose similar to factory. Mount T-block end onto chassis in factory location. (NOTE: Do not

install banjo onto master cylinder until lower hoses are installed). Insert supplied bushing into T-block so that

flange is between mounting surface and T-block (See Fig. 2).

Fig. 1

Fig. 2

Catalog #R09430, #R09431

Brochure #63-0490

Page 1 of 2

Rev. 3/06 - BC/mc